Timing Belt/Chain and Cover and Balance Shaft for 2012 Ram C/V
Chain Case Cover
M6x1.0x50.0. Camera ECU to Cowl. Camera ECU to Bracket. Front Support Bracket To Intake Manifold. Module To Bracket. Pump to Bracket. Left or Right. Camera ecu to brkt. Battery hold down to tray. Battery strap to battery tray.
Gasket
NOT Included With Long Block Engine Install Kit. Coolant Crossover.
Nut, Mounting
M6. Coolant Crossover. Sleeve/Bushing Oil Filter Adapter. Mounting, Timing Chain Cover. Insert Cylinder Head Cover. Cylinder Head Cover To Cylinder Head. Intake Manifold To Cylinder Head.
M6x1.00x25.00. Reinf plate to rambox inr. Crossover ot front cover. Crossover Attaching. Oil Pump. Crossover to timing cover. Crossover to frot cover. Crossover to front cover. Crossover to front pump. Pump To Front Cover.
M6x1.00x48.00. Crossover To Block. Crossover attaching. Water pump attaching. Timing cover, water pump, and crossover to engine. Coolant Crossover To Front Cover. Crossover to head.
Output Shaft to Engine. Timing Case Cover To Cylinder Head. M8x1.25x45.00. Front Cover to Head. Timing Case Cover To Cylinder Block.
Torx Head Bolt, Mounting, Primary
Left Bank Timing Drive Guide. Primary Tensioner. M6x1.00x30.00. Primary Drive Guide. Left Side Timing Cain Guide. Right Side. Left Side Timing Chain Guide. Timing Chain Gude.
Right Side. If A Short Block Engine Has Been Installed,The Timing Chain Guide Pins Are NOT Installed In The New Cylinder Block.Pin Kit 68146903AB Must Be Installed Before Timing System Can Be Installed. Secondary Right.
If A Short Block Engine Has Been Installed,The Timing Chain Guide Pins Are NOT Installed In The New Cylinder Block.Pin Kit 68146903AB Must Be Installed Before Timing System Can Be Installed. Secondary Left.
If A Short Block Engine Has Been Installed,The Timing Chain Guide Pins Are NOT Installed In The New Cylinder Block.Pin Kit 68146903AB Must Be Installed Before Timing System Can Be Installed.
Torx Head Bolt, Mounting Right Side
M6x1.00x15.00. Secondary Right Side Timing Chain Guide.
Idler Sprocket. Idler Shaft. M8x1.25x75.00. Iderl Sprocket.
M6x1.00x25.00. Reinf plate to rambox inr. Crossover ot front cover. Crossover Attaching. Oil Pump. Crossover to timing cover. Crossover to frot cover. Crossover to front cover. Crossover to front pump. Pump To Front Cover.
M8x1.25x16.00. Oil Pump To Drive Gear. [M8x16]. Oil Pump Sprocket. Sprinter. Intake Support Bracket To Cylinder Head.
Hex Flange Head Screw, Mounting
M5x0.8x12.0. Oil Pump Splash Shield To Oil Pump. Mounting DPS Heat Shield to DPF. Mounting DPF Routing Bracket and SCR Sensor. Tube attaching. Fuel Filter to Bracket. IP Carrier To Display Diecast. Pressure Tube Attachment. DPF Bracket to DPF.
